#ALPHA It is said that those who understand this post will never get stuck while brushing ALPHA again.
I feel that the reason everyone gets stuck is due to habitual thinking, so let’s clarify the logic below:
1. The price on the left is the transaction record price; it is not the buy or sell order price, which is different from spot and contracts！！！！Do not click this price as your limit buy and limit sell order price; this is the reason you get stuck.
2. You need to set the buy order price above the highest transaction record price on the left and the sell order price below the lowest transaction record price on the left, for example (see the picture for details):
(1) Highest transaction record price on the left: 0.123870000, so set your buy order to 0.124; (as long as it is not more than 5% higher than the highest price, if it’s higher when you click “Buy BAY,” there will be an extra confirmation which will waste time)
(2) Lowest transaction record price on the left: 0.12386880, so set your sell order to 0.123;
3. Once set, you can click “Buy BAY”; the transaction prices for buy and sell orders are the latest prices from the left transaction records, not the prices you set for buy and sell orders!!
4. Start brushing, and it will be executed in seconds, then continue to brush the next order.
The two most important points are:
1. Before brushing, make sure to check that the stability of alpha123 is 0; this is the most direct way to reduce wear. If the transaction record prices on the left are all the same, this is the best state, and brushing 33000 will only have 1.6u wear, it won’t be higher. Using the brushing method above, set the buy amount directly to 100%, fill the bullets. Setting the price outside the price range can lead to quick transactions, shortening the brushing time. (If you set the buy and sell order prices to be the same as the left transaction record prices, there will be a wait before the transaction completes, wasting time; think about whether you did this before)
2. If alpha 123 shows stability as 0 but the actual price is unstable, or alpha 123 shows stability as 0.0 something (below 0.1), you can still brush; it’s fine to use this technique. But!! At this time, you must lower the amount!! Small amounts multiple times, use 200U for brushing 33000, and 400U for brushing 66000;
You will have a bit more wear, more 0.0 something U, and there won’t be a situation where you get stuck for several U at once.
Do not doubt it; practice makes perfect. You go and brush, and after you finish, tell me how much wear you had? How long did it take?
Just work hard, and leave the rest to He Yi @Yi He .
